The simulator doesn't show any MDF Panels in 2D View; and in Cabin View (3D) if I select other MFD Panel, the simulator closes..
PS: MFD Panels runs only in "Direct3D HAL" in "Color Depth 16" '-'
Here is the three logs from the 2010, 2010+P1 and 2010+P2..
**** Orbiter.log
Build Aug 30 2010 [v.100830]
Timer precision: 2.79365e-007 sec
Found 0 joystick(s)
Devices enumerated: 3
Devices accepted: 3
==> RGB Emulation
==> Direct3D HAL
==> Direct3D T&L HAL
Module AtlantisConfig.dll .... [Build...
I have installed the versions: 111105, 121103 and Orbiter 2010 and I had some problems with the three versions.
I searched the Forum for help and found one that helped me a lot
http://orbiter-forum.com/showthread.php?t=28225
However, I have a new problem:
When I'm almost in orbit and...
Thank's Everybody!! I managed to solve my problems with Orbiter 100930. :blink:
I was configured the Orbiter using this Configurations:
----------------------------------------------------
PARAMETERS >> Instrument Glass Cockpit MFD >> MFD Refresh: 1.0 | Generic MFD size: 4 | Panel Scale: 1.0 |...
See:
-----------------------------------------------------
This diagnostic utility performs a few tests to verify a valid
Orbiter installation. Normally, this test needs to be executed
only once after installation. To run it again, execute the
'testinstall' utility in the Install subdirectory...
-------
3D device:
Direct 3D HAL
[x] Always Enumerate Devices [x] Try Stencil Buffer
Full Screen: 1024x768 -- 32 bit
Window: 800x600 -- 4:3 ratio
--------
:uhh:
:cry: from what I know, I have no video card does not. but even so, the 2006 orbiter takes normally.
I downloaded the 2010 because I wanted to play with the latest! is better and has more add-ons. :facepalm:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.