Software 2D panels lag like ...

[Mad Don]

Hi :tiphat:,
I ain´t really new to orbiter, but to the forum.
I started over with orbiter a month ago and get the D3D9Client(R12) while registered to the forum. Installed everything from scratch.
The D3D9Client runs smooth with some planet texture packs from the Orbiter downloadpage and some spaceplanes(XR series)+UCCO(UMMU)+Orbiter Sound 4.0. Well just like my old DX7-Orbiter(100830).

Now every XR vessel lags badly in 2D panel view (FPS shows 60 alltime). VC and Glasscockpit works fine.(FPS shows 60 alltime too).I run this config on a Intel(I5-2500),Intel HD 2000 graphics crap,8 G Ram.
I know the graphics adapter is really low end, but why does it run all smooth in VC, Glasscockpit and external view?
I searched already the forum, and found stuff like change the SketchPad settings to other then GDI. I got only the options GDI/DirectX or GDI.
Or change the font rendering. Turn off V-Sync.
I´ve done all of it, with no impact to my problem.

Anyone got an idea ?

 

[Ripley]

In D3D9 there a known issue with MAP MFD and the way it draws its land-contours.
Try to zoom it in some steps.

Hope it helps.

Edit: this was my post in the D3D9Client development thread:
http://www.orbiter-forum.com/showthread.php?p=383915&postcount=1673

 

[Mad Don]

Thanks for that fast response,

But Map MFD ain´t the problem since its not active. At least it don´t change a thing if Map MFD is open or not.

I noticed the framerate come back up, when i open an External MFD in 2DPanel view.
It´s kinda weird.

Edit:
Ok, i got it.
Turned the True Full Screen to Full Screen Window.
That sorted it for me.
Hopefully this helps some other newbie like me.

 

[Ripley]

Good you sorted it out.
That MapMFD thingie was a "just in case" heads up.