Project X-15 V2 problem

[Balladeer]

Hey there. I'm having trouble getting PX-15 V2 to work. I made a clean install of orbiter. I installed the CVEL Titans. I installed PX-15 V2. This is what my orbiter log says:

**** Creating simulation session
DirectDraw interface OK
Direct3D interface OK
Zbuffer: 32 bit
Stencil buffer: 8 bit
Render device: Fullscreen 1152 x 864
Device has no hardware T&L capability
Joystick throttle: SLIDER 0
Joystick throttle control detected
FAILED to create planetary system Sol_ProjectX-15
Check that Config\Sol_ProjectX-15.cfg exists and is valid

Now at looked at a previous post concerning this and tried the suggestions there. (copying and renaming sol.config to what was mentioned, delete old one and put this in its place. I also copied and pasted the second round of info on that post to a text.doc and named it and placed it into the general config file)

I just keep crashing back to desktop. Thanks for any help.

 

[Usonian]

You must download and install BOTH ProjectX-15 v2.0 and ProjectX-15 Edwards and High Range. (The description on Orbit Hangar for ProjectX-15 v2.0 mentions this requirement.) Sol_ProjectX-15.cfg is contained in Edwards and High Range.

Good luck and happy flying.

 

[Balladeer]

Thanks Usonian. I installed that addon. Orbiter loaded up farther this time but still crashed:

Finished initialising world
Module Spacecraft3.dll [API v.050206]
>>> ERROR: Missing texture: X-15\gb-x15-PanelD.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
>>> ERROR: Missing texture: X-15\gb-x15-PanelB.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
>>> ERROR: Missing texture: X-15\gb-x15-PanelA2.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
>>> ERROR: Missing texture: X-15\gb-x15-APULOX.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
>>> ERROR: Missing texture: X-15\gb-x15-TailTopRear.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
>>> ERROR: Missing texture: X-15\gb-x15-TailT.dds
>>> [C:\Source\Orbiter\Texture.cpp / 781]
**** WARNING: Mesh not found: .\Meshes\X-15\X-15_DropFin-gb.msh
**** WARNING: Mesh not found: .\Meshes\.msh

Should Edwards range be installed first before x-15? Is this an install order issue or something else?

 

[MJR]

Read the readme file. It should tell you.

 

[Balladeer]

I've read the requirements in the readme for X-15 Delta V2. I have cvel titans, now the high range and Delta V2 installed. The high range didn't seem to have a readme.

 

[Usonian]

I believe you need to install ProjectX-15 v2.0 first, then Edwards High Range, then X-15 Delta, in that order.

Let me know if that fixes you up.

 

[Balladeer]

I'll giver 'er a try thanks.

 

[unknown]

Read the instructions on Doc directory.