General Question Two VABs?

Here's the contents of the Earth_vab_files.log
Code:
---------- CONFIG\EARTH\BASE\CANAVERAL.CFG
[200] FILE vab
OK. There is only one "vab" entry in "Config/Earth/Base" folder, just where it should be.

And, has the "Earth.cfg" only one directory entry between "BEGIN_SURFBASE" and "END_SURFBASE", without additional directories or defined bases there?
 
I have a NVIDIA FX5200, and this IS orbiter 06

A quote:
It's been like this for a while, but since I got 2010 Iv'e only just noticed it.
You told "since you got 2010", so I assumed it's happening in Orbiter 100606, after you installed a bunch of add-ons, from which one might cause this issue.

So, is it happening in Orbiter 060929 since you installed Orbiter 100606 somewhere else, or have you installed Orbiter 100606 to previously installed 060929's folder (or vice-versa), and it's happening since then, or you haven't installed Orbiter 2010 at all, and this issue just appeared in Orbiter 060929 when you only downloaded Orbiter 2010's archive without unpacking it?

Please be consistent in your reports, and if you want us to help you, please try to give us as much information as you can, otherwise we won't be able to help you. If you don't want us to help you, just start over again from a clean Orbiter installation, and next time this issue will happen on that new installation, try to remember what you did just prior to it, to post it here.
 
did you install orbiter 2010 OVER 2006? that is a BAD thing to do.

--edit--

Hmm, the alignment appears to say that you have a legacy 2006 KSC and the new 2010 KSC. definitely look for duplicate files or ones that have (2) appended to them.
 
Last edited:
Sorry guys, I wasn't being specific. What I meant was these screens are from orbiter 2006 and it is in 06 that I am experiencing this problem. There is nothing wrong with my 2010 install, probably because I haven't got many addons on it. Just the XR-series, AMSO, DGIV and UCGO and wideawake intl
 
Back
Top